Suppressor Cover

To keep the cover firmly in place, it features low-profile cam buckles that securely cinch around your suppressor without adding bulk. A protective velcro flap neatly hides any excess webbing and cordage, giving it a clean, streamlined look that is snag-free. At the rear, a cinch collar prevents forward sliding, keeping the cover locked exactly where you want it, shot after shot.

Disclaimer: This cover is not recommended for use with 5.56/.223 SBRs, magazine dumps, or any form of rapid-fire shooting.These applications generate excessive heat and can result in permanent damage to the cover.

• Carbon Fiber Fabric Sleeve Rated up to 1800 degrees
• 1000D Cordura Exterior
• High quality fire resistant Nomex thread
• Melt Proof Technora cinch cord

• 5 inches - 2.4 oz
• 6 inches - 2.6 oz
• 7 inches - 2.8 oz
• 8 inches - 3.2 oz
• 9 inches - 3.4 oz

Measure your suppressor from end to end, not including the muzzle brake if equipped. Choose the cover length that matches or leaves 1/8"–1/4" exposed, if you are between sizes please reach out to us. For example, if your suppressor measures 7 inches, choose the 7 inch cover. Once it’s installed and cinched at the back, you’ll have the proper amount of room at the end. This small gap helps hot gases escape and keeps the cover from getting damaged by excess heat.

The carbon material will naturally wear over time, as with all suppressor covers due to heat and regular use. We offer a repair service for $20. You cover the shipping to us, we’ll handle the repair, and we’ll cover the shipping back to you.

Normal wear and tear outside of the carbon material is covered under our lifetime warranty.

Damage caused by neglect, such as shooting it off because it was not installed correctly, is not covered. However, reach out to us and we’ll work with you to find a solution.